Abstract
Geometric calibration of digital light processing projectors in single-camera, fringe-projecting 3D measurement systems have been studied assuming the projector is inverse pinhole modeled. Conversely, a high-speed multi-aperture array projector (MAAP) projecting aperiodic fringes is not dependent on a digital mirror device and cannot be pinhole modeled. With MAAP projection, a stereo camera setup is required. This paper presents a model-less method to calibrate a MAAP by direct measurement of its illumination field and re-enables 3D measurements with a single camera even with surface discontinuities present. Experimental proof of principle and preliminary measurement performance are shown.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
