Abstract

Soil dielectric properties are commonly used to estimate soil water content, however, the relative permittivity of common soil minerals is often unknown or estimated to be 5, similar to quartz (4.6). In this study, the Clausius–Mosotti model is used to estimate mineral relative permittivity from atomic polarizability for common soil minerals. Atomic polarizabilities are used to calculate the average mineral polarizability using the oxide additivity rule. Results of these calculations are compared with measurements found in the literature for rock and mineral samples. Predictions correspond well with measurements on single crystals or obtained using the immersion method to determine relative permittivity (better than 10%). The application of this simple calculation technique allows estimates of relative permittivity to be obtained for minerals for which it is difficult to measure relative permittivity directly, such as soil clay minerals.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.