Abstract
A ball endmill made of single-crystalline diamond was used for cutting two kinds of mold materials, oxygen-free copper and reaction-bonded silicon carbide (RB-SiC). The cutting performance of the ball endmills was investigated by examining surface roughness and form accuracy of the machined workpiece as well as tool wear characteristics. It was found that micro lens arrays and grooves with extremely smooth surface and high-accuracy profile could be obtained on oxygen-free copper without detectable tool wear. When machining RB-SiC, although ductile cutting was realized, a few fine streaks were observed on the machined surface, which were attributed to the flank wear of the diamond tool. The effects of tool feed condition on cutting performance of a worn tool was investigated by performing micro grooving tests.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Proceedings of International Conference on Leading Edge Manufacturing in 21st century : LEM21
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
