C1 Lateral Mass Screw Placement Through Endonasal Corridor for Purpose of O-C1 Fusion: Morphometric Analysis in Cadaveric Specimens

Abstract

Odontoidectomy may pose some risks for O-C1 and/or C1-C2 instability, with previous authors reporting techniques for endonasal C1-C2 fusion. However, no technique for endonasal O-C1 fusion currently exists. We sought to describe the feasibility of endonasal anterior C1 (AC1) screw placement for endonasal O-C1 fusion. Seven adult cadaveric heads were studied for endonasal placement of 14 C1 screws. Using thin-cut computed tomography (CT)-based "snapshot" neuronavigation assistance, 4 mm x 22 mm screws were placed in the C1 lateral mass using a 0° driver. Post-placement CT scans were obtained to determine site-of-entry measured from C1 anterior tubercle, screw angulation in axial and sagittal planes, and screw proximity to the central canal and foramen transversarium. Average site-of-entry was 16.57 mm lateral, 2.23 mm rostral, and 5.53 mm deep to the anterior-most portion of the C1 ring. Average axial angulation was 19.49° lateral to midline, measured at the C1 level. Average sagittal angulation was 13.22° inferior to the palatal line, measured from the hard palate to the opisthion. Bicortical purchase was achieved in 11 screws (78.6%). Partial breach of the foramen transversarium was observed in 2 screws (14.3%), violation of the O-C1 joint space in 1 (7.1%), and violation of the central canal in 0 (0%). Average minimum screw distances from the unviolated foramen transversaria and central canal were 1.97 mm and 4.04 mm. Navigation-assisted endonasal placement of AC1 screws is feasible. Additional studies should investigate the biomechanical stability of anterior C1 screw-plating systems, with anterior condylar screws as superior fixation point, compared to traditional posterior O-C1 fusion.