Abstract

One of major problems facing motorists in Dar es Salaam city today is congestion. Bus bays have a significant influence on the capacity of a roadway because they interfere with passing vehicles primarily when buses maneuver to pull into and out of bus bays. Bus bay stops will also interfere with vehicles movement if bus demand exceeds the bus bay capacity resulting in some buses waiting in the travel lane until the buses occupying the bay exit the bay. This paper presents the results of a study which was carried out to evaluate the bus bay performance and its influence on the capacity of the roadway network in the city of Dar es Salaam. The case study area covered 11 bus stops along Morogoro road from Ubungo to Magomeni Mapipa. Capacity of bus bays was studied using procedure outlined in the Transit Capacity and Quality of Service Manual of 2003. This enabled the researcher to determine parameters such as dwell times and clearance times which are major determinants of bus stop capacity. The results indicate that only 18% of the bus bay stops studied did not have adequate capacity to cater for the available demand. 9% did not have adequate capacity during peak hours but the capacity was adequate during off-peak hours. The remaining 73% of bus bay stops possess adequate capacity all the time. Although most bus bay stops studied possess adequate capacity, severe congestion was observed at these locations. This is due to erratic behavior of bus drivers who do not utilize the provided space for them to drop off and pick up passengers. Clearly, this is an area that requires more strict enforcement in order to ease the congestion problem in the city by operating the existing capacity more efficiently.

Highlights

  • Bus bay type of bus stop is constructed and separated from travel lanes and off normal section of a roadway that provides for the pickup and discharge of passengers

  • The results indicate that only 18% of the bus bay stops studied did not have adequate capacity to cater for the available demand. 9% did not have adequate capacity during peak hours but the capacity was adequate during off-peak hours

  • The remaining 73% of bus bay stops possess adequate capacity all the time

Read more

Summary

Introduction

Bus bay type of bus stop is constructed and separated from travel lanes and off normal section of a roadway that provides for the pickup and discharge of passengers. This design is meant to allow through traffic to flow freely without the obstruction of stopped buses. There might be several reasons why buses do not stop closely at curbs including technical and psychological issues as well as traffic condition. This situation can be alleviated by providing properly designed bus bays (Nakamura et al, 2005)

Methods
Findings
Discussion
Conclusion
Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.