Abstract

Preheating conditions (low-, medium-, and high heat-) did not significantly affect the buffering capacity (BC) of skim milk powder (SMP), whereas the level of demineralization significantly affected the BC of whey powders (WP). Heat treatment (85°C for 30 min) of both SMP and WP (90% demineralized) mixtures (88:12, 76:24, 64:36 and 52:48; SMP:WP) resulted in a reduced BC, and the extent of this reduction increased with the proportion of WP increased in the samples. High-buffering milk prepared by the addition of phosphate salts (40 mM NaH2PO4 and 60 mM Na2HPO4) delayed the rate of pH decline during yoghurt fermentation. The high-buffering yoghurt showed a significantly higher water holding capacity (WHC) than that of control yoghurt (p<0.05), as well as a more uniform and interconnected microstructure with small pore sizes than those of control yoghurt. No significant differences were found between high-buffering and control yoghurt regarding the viable bacterial counts of starter. The manipulation BC can potentially improve the quality characteristics of yoghurts, such as WHC and texture.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.