Buckling of spherical sandwich shells

Abstract

An experimental investigation was carried out to determine the critical buckling loads of several shallow spherical sandwich shells. A cold-forming process simultaneously using pressure and vacuum was employed to manufacture the nearly perfect spherical facing layers from 5052 aluminum-alloy sheets of 0.006 and of 0.008-in. thicknesses. Eight shallow spherical-shell specimens of 20-in. base diameter and of 20 and 30-in. radii with 1/8 and 1/4-in. thickness of “Flexcore” have been tested in a 300-psi autoclave specifically designed for these experiments. The pressure on shells was developed by the differential pressure between the inner and the outer chambers separated by the shell being tested. When the inner chamber was maintained at atmospheric pressure and gas pressure was applied in the outer chamber, the testing procedure was termed “soft.” Alternatively, the inner chamber would be filled with fluid with the outer chamber remaining filled with gas. By initially pressurizing both chambers equally, a load on the shell could be developed by the differential pressure due to controlled bleeding of the fluid inside the inner chamber, while the gas in the outer chamber was maintained at the initial pressure. This is an accurate volume-control experiment and this testing procedure was termed “hard.” In the latter case, it was possible to monitor the displacements of the shell for each load increment with a nest of clip gages of an unique design. It was found that there is no substantial difference in the buckling loads between the hard and “soft” systems. All shells buckled in the plastic range. A reasonably good correlation is obtained with a linear theory using the double modulus for the sandwich segments.