Bubble growth, departure and rising of ethane at nucleate pool boiling condition

Abstract

Boiling heat transfer exists in many industrial heat exchangers such as the evaporator of the refrigerator and the air conditioner, the reboiler of the chemical equipment and steam generator of the nuclear reactor. In the process of boiling, bubble movement can speed up the heat transfer between liquid and solid, leading to the improvement in heat transfer efficiency. Traditional refrigerants used in the industrial facilities have serious environmental problems, therefore, new substitutes are needed. Hydrocarbons are good alternatives. Ethane was suggested as one component of a mixed- refrigerant for its zero ozone depletion potential, low global warming potential and high thermodynamic properties. Therefore, it is important to investigate the bubble behavior of ethane in saturated nucleate pool boiling to design and optimize the industrial equipment like evaporator, improve natural gas liquefaction technology, and research characteristics of heat transfer and multiphase flow as well. Although there are a lot of researches on the heat transfer characteristics of pool boiling, the research on the bubble behavior in ethane is still lacking. In this paper, visualization experiments on the pool boiling heat transfer characteristics of ethane were carried out at 0.2 MPa. The heat fluxes varied from 14.65 kW m−2 to 80.79 kW m−2. Boiling occurred on the upward facing side of a smooth vertical copper cylinder with 20 mm diameter, connected to a DC power supply to control the heat flux on the surface. The measured roughness of the surface was 68.1 nm (root mean square average of the height deviations) and 50.7 nm (the arithmetic average of the absolute values of the surface height deviations). Acquisition of the temperature and pressure was accomplished by using a Keithley 2700 and six thermocouples. The experimental apparatus has a steel ruler inside the pool as the reference length to measure the bubble sizes and the maximum uncertainty for length measurement is 0.060 mm. Some conclusions can be drawn. (1) According to the change of diameter with time, the growth process was divided into three stages. The bubble growth process has obvious segmentation characteristics, and piecewise prediction models are recommended. (2) The bubbles in boiling pool exhibit the characteristics of axial symmetry and uneven distribution; the shape of separation of ethane bubbles has ellipsoidal and irregular shapes relative to normal temperature liquids. (3) There were trail changes and additional movements of large bubbles. Compared to normal temperature liquids, the trail changes were relatively simple; and the bubbles are bubbly and slug flow of two flow regimes. (4) System pressure, heating wall properties like surface roughness, liquid properties like contact angle and surface tension have an important influence on bubble behavior. This paper suggests that the heat transfer prediction equation should consider them.