Abstract
Deep-learning-based identification and diagnosis of faults in industrial assets has received much attention. It does not need a deep understanding of the target domain or complex signal-processing techniques for time-consuming feature identification and selection. The vast majority of approaches developed in this field rely on public data recorded in laboratory conditions with high-performance measurement equipment. Moreover, primarily vibration data is used for condition monitoring tasks, which is particularly sensitive to typical error patterns in rotating machinery. These conditions are difficult to maintain in industrial environments since using high-performance measurement systems would not be economically feasible. This paper demonstrates that modern deep learning can achieve extraordinary fault detection results with industrial standard low-cost measurement systems. We determine measurements taken from the industrial-sensory equipment that potentially capture the system’s fault patterns. Hereafter, we apply traditional failure detection and identification techniques to evaluate the suitability of the taken measurements for bearing fault detection. These techniques apply envelope analysis to reveal the fault patterns in the signals and a support vector machine to separate the fault classes. We can conclude that the used low-cost sensory equipment is capable to capture meaningful, fault-describing patterns. To improve the failure detection performance we are investigating a 2D, as well as 1D, convolutional neural network approach to identify the error patterns and classify the respective errors. We compare the deep-learning-based methods with the traditional methods. Furthermore, we assess which inverter signal carries the largest fault-describing information content. Experimental results indicate that the proposed deep learning methods outperform traditional fault diagnosis methods, hence, demonstrating the effectiveness in an industrial condition monitoring application.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have