Abstract

Bisphenol A (BPA) is an endocrine-disrupting chemical used in the production of plastics, and is linked to developmental, reproductive, and metabolic disorders including obesity. Manufacturers have begun using ‘BPA-free’ alternatives instead of BPA in many consumer products. However, these alternatives have had much less testing and oversight, yet they are already being mass-produced and used across industries from plastics to food-contact coatings. Here, we used human female adipose-derived stem cells (hASCs), a type of adult mesenchymal stem cell, to compare the effects of BPA and BPA alternatives on adipogenesis or fat cell development in vitro. We focused on two commonly used BPA replacements, bisphenol AF (BPAF) and tetramethyl bisphenol F (TMBPF; monomer of the new valPure V70 food-contact coating). Human ASCs were differentiated into adipocytes using chemically defined media in the presence of control differentiation media with and without 17β-estradiol (E2; 10 μM), or with increasing doses of BPA (0, 0.1 and 1 μM), BPAF (0, 0.1, 1 and 10 nM), or TMBPF (0, 0.01 and 0.1 μM). After differentiation, the cells were stained and imaged to visualize and quantify the accumulation of lipid vacuoles and number of developing fat cells. Treated cells were also examined for cell viability and apoptosis (programmed cell death) using the respective cellular assays. Similar to E2, BPA at 0.1 μM and BPAF at 0.1 nM, significantly increased adipogenesis and lipid production by 20% compared to control differentiated cells (based on total lipid vacuole number to cell number ratios), whereas higher levels of BPA and BPAF significantly decreased adipogenesis (p < 0.005). All tested doses of TMBPF significantly reduced adipogenesis and lipid production by 30–40%, likely at least partially through toxic effects on stem cells, as viable cell numbers decreased and apoptosis levels increased throughout differentiation. These findings indicate that low, environmentally-relevant doses of BPA, BPAF, and TMBPF have significant effects on fat cell development and lipid accumulation, with TMBPF having non-estrogenic, anti-adipogenic effects. These and other recent results may provide a potential cellular mechanism between exposure to bisphenols and human obesity, and underscore the likely impact of these chemicals on fat development in vivo.

Highlights

  • Bisphenol A (BPA) is a well-known endocrine-disrupting chemical (EDC) and identified obesogen, which is a chemical that can disrupt or increase normal fat development and lipid metabolism and may cause obesity

  • In order to determine the potential toxicity of low-dose BPA, bisphenol AF (BPAF), and tetramethyl bisphenol F (TMBPF), human female adipose-derived stem cells (hASCs) were exposed to various doses of the BPA analogs for 2 to 24 h

  • TMBPF at 0.1 μM showed some increases in cell death following 20 min, 2 h, and 24 h of exposure, but not complete cell death (Figure 2), whereas all higher doses resulted in significant toxicity and cell death

Read more

Summary

Introduction

Bisphenol A (BPA) is a well-known endocrine-disrupting chemical (EDC) and identified obesogen, which is a chemical that can disrupt or increase normal fat development and lipid metabolism and may cause obesity. BPA’s ability to leach out of products has caused significant amounts to be detected in water and soil systems, along with wastewater from construction and recycling treatment sites [1,4,7,8,13,14,15,16,17,18,19,20,21]. Several previous studies have demonstrated that BPA levels present in these systems are capable of detrimental effects on living organisms, including humans [4,12,15,22,23,24]. Multiple studies report that significant amounts of BPA are present in the global human population’s blood and urine [25,26,27,28,29,30].

Objectives
Methods
Results
Conclusion
Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.