Box-Behnken design optimization of 2D Ti3C2Tx MXene nanosheets as a microwave-absorbing catalyst for methylene blue dye degradation

Abstract

The 2D MXene Ti3C2Tx was synthesized from the precursor MAX phase Ti3AlC2 by etching the Al layer using hydrofluoric acid. Different Characterization techniques were employed to investigate the properties of the synthesized Ti3C2Tx. The degradation of methylene blue (MB) dye under microwave irradiation in the presence of the prepared 2D MXene was studied. It was found that the synthesized Ti3C2Tx was an excellent microwave catalyst for MB dye degradation, and results obtained were promising. Using this approach, the dye was almost wholly degraded with a degradation efficiency of 99.85 % in only 10 min without adding any oxidant. The degradation was found to follow the pseudo-first-order kinetic model, and the rate constants obtained varied from 0.10 and reached up to 0.67 min−1. The effect of pH, initial MB concentration and catalyst dosage on the MB dye degradation rate has been studied. It was found that carrying out the reaction at pH values ranging from 2 to 10 did not obviously affect its rate. On the other hand, lower initial MB dye concentrations and higher catalyst dosages significantly increased the degradation rate. The high degradation efficiency was found to be maintained for up to five successive catalytic cycles, ensuring the high stability of the synthesized 2D MXene Ti3C2Tx as a catalyst. Optimization of parameters affecting the degradation process was studied using response surface methodology (RSM). According to the Box-Behnken design, the optimal degradation efficiency (99.92 %) could be achieved by adding 21.24 mg of 2D Ti3C2Tx MXene catalyst and using an initial MB dye concentration of 53.06 ppm (mg/L) during a reaction time of 11.93 min.