Abstract

AbstractEffects of boundary conditions on the performance of compact oscillatory momentum and vorticity generators, commonly known as ‘synthetic jet’, ejecting a train of vortex-pairs into still air, were studied experimentally. The different boundary conditions altered the near-device entrainment process of the zero-net-mass-flux actuator. The measurements included hot-wire and Particle Image Velocimetry, cavity pressures and temperatures.When the actuator operates in still air, a quasi-2D vortex pair is generated due to the extreme shear at the edges of the fluid slug ejected during the blowing stage of each excitation cycle. The vorticity flux exiting the slot determines the resulting vortex-pair circulation. The threshold slot exit velocity, for the current configuration and operating conditions, determines if the vortices will be sucked into the actuator’s cavity or be released. Once released, the vortex convection speed approximately scales with the peak velocity at the slot exit. However, the normalised convection velocity increases with the slot Reynolds number.When even a very short extension is attached to one ‘lip’ of the actuator exit, the jet is deflected in the direction opposite the extended lip, due to the restriction on the entrainment process. When long, one ‘lip’ extension is attached, such that the vortex pair is ejected parallel to a plate, the coherence of the vortices improve, their phase speed and magnitude decrease.The effects of high-frequency excitation, ejected perpendicular to a wall into still air, were also investigated. It was found that the presence of the plate does not have a measurable effect on the wall normal excitation, indicating that the majority of the entrainment is taking place from the forward 180° of the actuator exit plane. When the slot is inclined to the surface at a shallow angle of 30 degrees, an unsteady wall jet is formed, transferring momentum along the wall. This is a direct result of the symmetry break, altering the relative magnitudes of the vortex pair.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.