Abstract
The effects of blending methods on mechanical and morphological properties of CaCO3/LDPE and fly ash/LDPE composites were investigated as a function of filler loadings. The CaCO3/LDPE and fly ash/LDPE composites considered in this work were prepared by dry blending (high-speed mixer) and melt blending (using single- and twin-screw extruders). It was found that as the CaCO3 or FA loading was increased, the modulus and hardness for all blending techniques were increased, due to rigidities of the fillers and increased crystallinity level of the composites. Increasing the CaCO3 and FA loadings decreased the ultimate mechanical properties (tensile strength, elongation at break and impact strength) due to poor dispersion and interfacial defects of the composites. Composites prepared by the twin-screw extruder had the best mechanical properties as compared to those prepared by the dry blending or single-screw extruder, except for the impact strength. The overall mechanical properties of LDPE composites with CaCO3 were similar to those with FA particles, but the changes in the composite properties with CaCO3 particles were more sensitive than those with FA particles, this being associated with the differences in particle characteristics and dispersion level of CaCO3 or FA fillers.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.