Blade Tip Carving Effects on the Aerothermal Performance of a Transonic Turbine

Abstract

Tip leakage flows in unshrouded high speed turbines cause large aerodynamic penalties, induce significant thermal loads and give rise to intense thermal stresses onto the blade tip and casing endwalls. In the pursuit of superior engine reliability and efficiency, the turbine blade tip design is of paramount importance and still poses an exceptional challenge to turbine designers. The ever-increasing rotational speeds and pressure loadings tend to accelerate the tip flow velocities beyond the transonic regime. Overtip supersonic flows are characterized by complex flow patterns, which determine the heat transfer signature. Hence, the physics of the overtip flow structures and the influence of the geometrical parameters require further understanding to develop innovative tip designs. Conventional blade tip shapes are not adequate for such high speed flows and hence, potential for enhanced performances lays in appropriate tip shaping. The present research aims to quantify the prospective gain offered by a fully contoured blade tip shape against conventional geometries such as a flat and squealer tip. A detailed numerical study was conducted on a modern rotor blade (Reynolds number of 5.5 × 105 and a relative exit Mach number of 0.9) by means of three-dimensional (3D) Reynolds-averaged Navier–Stokes (RANS) calculations. Two novel contoured tip geometries were designed based on a two-dimensional (2D) tip shape optimization in which only the upper 2% of the blade span was modified. This study yields a deeper insight into the application of blade tip carving in high speed turbines and provides guidelines for future tip designs with enhanced aerothermal performances.