Abstract

Abstract. Black carbon (BC) aerosol at high altitudes of the Qinghai–Tibetan Plateau has potential effects on the regional climate and hydrological cycle. An intensive measurement campaign was conducted at Qinghai Lake (~ 3200 m above sea level) at the edge of the northeastern Qinghai–Tibetan Plateau during winter using a ground-based single particle soot photometer (SP2) and a photoacoustic extinctiometer (PAX). The average concentration of refractory BC (rBC) and number fraction of coated rBC were found to be 160 ± 190 ng m−3 and 59 % for the entire campaign, respectively. Significant enhancements of rBC loadings and number fraction of coated rBC were observed during a pollution episode, with an average value of 390 ng m−3 and 65 %, respectively. The mass size distribution of rBC particles showed log-normal distribution, with a peak diameter of ~ 187 nm regardless of the pollution level. Five-day backward trajectory analysis suggests that the air masses from north India contributed to the increased rBC loadings during the campaign. The potential source contribution function (PSCF) model combined with the fire counts map further proves that biomass burning from north India is an important potential source influencing the northeastern Qinghai–Tibetan Plateau during the pollution episode. The rBC mass absorption cross section (MACrBC) at λ = 532 nm was slightly larger in clean days (14.9 m2 g−1) than during the pollution episode (9.3 m2 g−1), likely due to the effects of brown carbon and the uncertainty of the MACrBC calculation. The MACrBC was positively correlated with number fraction of coated rBC during the pollution episode with an increasing rate of 0.18 (m2 g−1) %−1. The number fraction of coated rBC particles showed positive correlation with light absorption, suggesting that the increase of coated rBC particles will enhance the light absorption. Compared to rBC mass concentration, rBC mixing sate is more important in determining absorption during the pollution episode, estimated from the same percentage-wise increment of either rBC mass concentration or the number fraction of coated rBC. The estimated BC direct radiative forcing was +0.93 W m−2 for the pollution episode, which is 2 times larger than that in clean days. Our study provides insight into the potential climatic impacts of rBC aerosol transported to the Qinghai–Tibetan Plateau from south Asian regions, and is also useful for future modeling studies.

Highlights

  • Black carbon (BC) aerosol has received worldwide concern due to its effects on climate and human health (Anenberg et al, 2012; Bond et al, 2013)

  • It is found that ∼ 25 % of the refractory BC (rBC) values are higher than the 75th value, and the variation coefficient (defined by standard deviation (SD) / mean ratio) of rBC values reaches as high as 120 %, suggesting a large rBC burden even at the free tropospheric altitude

  • The mean number fraction of coated rBC increases to 65 % during the pollution episode, higher than that in the clean days (58 %)

Read more

Summary

Introduction

Black carbon (BC) aerosol has received worldwide concern due to its effects on climate and human health (Anenberg et al, 2012; Bond et al, 2013). A total climate forcing of BC particles is estimated to be +1.1 W m−2, which is ranked as the second largest contributor to anthropogenic radiative forcing after carbon dioxide in the present-day atmosphere (Bond et al, 2013). BC particles, derived from incomplete combustion of fossil fuels or biomass, are mainly hydrophobic when emitted, but become hygroscopic over time due to atmospheric aging processes (Cheng et al, 2006, 2012). BC shows semi-direct effects through interaction with cloud processes (Koch and Del Genio, 2010). The impacts of BC aerosols on the radiative balance may lead to far-reaching consequences, such as global dimming (Wild et al, 2007), lower crop yields (Tollefsen et al, 2009), and negative impacts on terrestrial and aquatic ecosystems (Forbes et al, 2006)

Objectives
Methods
Results
Conclusion
Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call