Abstract
This paper reports galvanomagnetic properties of arrays of single-crystal bismuth nanowires, with diameters of 7 to 200 nm, embedded in an amorphous porous anodic alumina matrix. A sample preparation technique is described that makes it possible to obtain nanowires with diameters below 10 nm. The wires are single crystals, with their long axes oriented in the bisectrix/trigonal plane, about 19\ifmmode^\circ\else\textdegree\fi{} from the bisectrix axis. The temperature dependence $(1.4\mathrm{K}l~Tl~300\mathrm{K})$ of the electrical resistance, longitudinal magnetoresistance $(0\mathrm{T}l~Bl~5\mathrm{T}$ with $1.4l~Tl~75\mathrm{K},$ and $0Tl~Bl~1\mathrm{T}$ with $80l~Tl~300\mathrm{K})$ and transverse magnetoresistance $(0\mathrm{T}l~Bl~5\mathrm{T}$ with $1.4l~Tl~75\mathrm{K})$ of the nanowires are given. The results extend previous work to wires of narrower diameter, and confirm the existence of the semimetal-semiconductor phase transition seen in the magnetoresistance. The data are discussed qualitatively in terms of the interplay between the electron cyclotron radii, electron scattering on the wire walls, size-induced energy level quantization, and the transfer of carriers between the different carrier pockets of the Fermi surface. Nanowires of Bi are theoretically predicted to have a much higher thermoelectric figure of merit than bulk Bi.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.