Birefringent optical fibers to decouple thermo-mechanical effects on FBG sensors

Abstract

Optical fiber Bragg (FBG) sensors are gaining importance in structural health monitoring (SHM) systems due to their compact size and ability to be embedded into the lamination sequences of composite material elements. A significant challenge, widely discussed in the literature, concerns the decoupling of thermomechanical measurements made through these sensors. This work aims to solve this problem using birefringent optical fibers instead of conventional ones. The distinctive characteristics of birefringent fibers allow an FBG sensor, written in such fibers, to present not a single peak but two distinct peaks, each with different responses to changes in strain and temperature. This is due to the different refractive index distribution in the fiber core section, which allows for two axes on which the light signal propagates at different speeds. This property offers a significant advantage: by having two independent equations associated with the two peaks, it is possible to decouple the thermomechanical measurements using only the fiber itself, without the need to introduce additional components to achieve mechanical decoupling (capillaries with through or interrupted fiber). This would ensure that strain and temperature are measured at the same point. In the first phase of the work, an FBG sensor on a birefringent fiber was characterized and subsequently calibrated. Therefore, a dedicated experimental set-up was created to conduct thermal, mechanical, and thermomechanical characterization tests, in order to verify the feasibility and effectiveness of decoupling. In a second step, such sensor was embedded within a sample of composite material (unidirectional glass fibers), which was subsequently subjected to the same characterization tests conducted on the single fiber. The results highlight the ability of this new transducer to decouple the thermal effect from the mechanical effect, allowing this new technology to overcome the problems of FBG sensors made of standard fibers.