Abstract
The physicochemical characteristics of three Brazilian peats were investigated using elemental analysis, scanning electron microscopy (SEM), X-ray diffractometry (XRD) and studies of Cr(III) biosorption based on adsorption isotherms. Adsorption of Cr(III) by in natura peat from Santo Amaro das Brotas (Sergipe State) was much greater than by peats from either Ribeirão Preto (São Paulo State) or Itabaiana (Sergipe State), with adsorption capacities ( q) of 4.90 ± 0.01, 1.70 ± 0.01 and 1.40 ± 0.01 mg g −1, respectively. Pre-treatments with HCl and NaOH + HCl reduced adsorption by the Santo Amaro das Brotas peat, showing that adsorption efficiency was associated with the amount of organic matter present. Conversely, increase in the mineral content following pre-treatment increased adsorption of Cr(III) by the Ribeirão Preto and Itabaiana peats. Highest adsorption (retention >95.0%) was achieved at equilibrium pH 4.0 using the Santo Amaro das Brotas peat. Experimental data for the adsorption of Cr(III) from aqueous solution onto this peat were fitted to the Langmuir equation, from which an equilibrium adsorption capacity, q max, of 5.60 mg g −1 was obtained, which was close to the experimentally determined value.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
