Biomechanical in vitro evaluation of the kangaroo spine in comparison with human spinal data.

Abstract

On the basis of the kangaroo's pseudo-biped locomotion and its upright position, it could be assumed that the kangaroo might be an interesting model for spine research and that it may serve as a reasonable surrogate model for biomechanical in vitro tests. The purpose of this in vitro study was to provide biomechanical properties of the kangaroo spine and compare them with human spinal data from the literature. In addition, references to already published kangaroo anatomical spinal parameters will be discussed. Thirteen kangaroo spines from C4 to S4 were sectioned into single-motion segments. The specimens were tested by a spine tester under pure moments. The range of motion and neutral zone of each segment were determined in flexion and extension, right and left lateral bending and left and right axial rotation. Overall, we found greater flexibility in the kangaroo spine compared to the human spine. Similarities were only found in the cervical, lower thoracic and lumbar spinal regions. The range of motion of the kangaroo and human spines displayed comparable trends in the cervical (C4-C7), lower thoracic and lumbar regions independent of the motion plane. In the upper and middle thoracic regions, the flexibility of the kangaroo spine was considerably larger. These results suggested that the kangaroo specimens could be considered to be a surrogate, but only in particular cases, for biomechanical in vitro tests.