Biomechanical impact of meniscal ramp lesions on knee joint contact characteristics in ACL deficient knees: a cadaveric analysis.

Abstract

To evaluate the changes in contact characteristics of the tibiofemoral joint resulting from a meniscal ramp lesion in the medial meniscus. Twelve cadaveric knees (six matched pairs) were subjected to a 600N axial load using a custom testing jig, which allowed for knee positioning at 0°, 45°, and 90° of flexion without other constraints. The knees were randomly assigned to either a ramp lesion group (n = 6) or a posterior root lesion group (n = 6). Four testing conditions were examined: (1) intact, (2) isolated ramp lesion, (3) isolated posterior root tear of the medial meniscus, and (4) combined ramp lesion and posterior root tear of the medial meniscus. Contact characteristics were evaluated using a flexible pressure sensor, the I-Scan System. Peak contact pressure in isolated ramp lesions (4.15 ± 0.98MPa, P = 0.206) showed non-significant increases compared to the intact condition (3.86 ± 1.32MPa). Peak contact pressure in isolated posterior root tears (4.58 ± 1.70MPa, P = 0.040) and, combined ramp and posterior root lesions (4.67 ± 1.47MPa, P = 0.003) were significantly higher than that in the intact condition. The knee flexion position significantly affected the medial tibiofemoral joint's contact area, contact pressure, and peak contact pressure (P < 0.001 for all). Isolated ramp lesions did not significantly impact force transmission, contact area, or contact pressure. In contrast, isolated root lesions and combined ramp and posterior root tears of the medial meniscus significantly intensified the changes in contact characteristics in the medial tibiofemoral joint compared to the intact condition. Level III.