Abstract
This study used image-based finite element analysis (FEA) to assess the biomechanical changes in mandibular first molars resulting from alterations in the position of the root canal isthmus. A healthy mandibular first molar, characterized by two intact root canals and a cavity-free surface, was selected as the subject. A three-dimensional model for the molar was established using scanned images of the patient's mandibular teeth. Subsequently, four distinct finite element models were created, each representing varied root canal morphologies: non-isthmus (Group A), isthmus located at the upper 1/3 of the root (Group B), middle 1/3 of the root (Group C), and lower 1/3 of the root (Group D). A static load of 200 N was applied along the tooth's longitudinal axis on the occlusal surface to simulate regular chewing forces. The biomechanical assessment was conducted regarding the mechanical stress profile within the root dentin. The equivalent stress (Von Mises stress) was used to assess the biomechanical features of mandibular teeth under mechanical loading. In Group A (without an isthmus), the maximum stress was 22.2MPa, while experimental groups with an isthmus exhibited higher stresses, reaching up to 29.4MPa. All maximum stresses were concentrated near the apical foramen. The presence of the isthmus modified the stress distribution in the dentin wall of the tooth canal. Notably, dentin stresses at specific locations demonstrated differences: at 8mm from the root tip, Group B: 13.6MPa vs. Group A: 11.4MPa; at 3mm from the root tip, Group C: 14.2MPa vs. Group A: 4.5MPa; at 1mm from the root tip, Group D: 25.1MPa vs. Group A: 10.3MPa. The maximum stress in the root canal dentin within the isthmus region was located either at the top or bottom of the isthmus. A root canal isthmus modifies the stress profile within the dentin. The maximum stress occurs near the apical foramen and significantly increases when the isthmus is located closer to the apical foramina.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have