Biomechanical evaluation of the pedicle screw insertion depth and role of cross-link in thoracolumbar junction fracture surgery: a finite element study under compressive loads

Abstract

Introduction. The thoracolumbar junction is one of the most frequently damaged parts of the human spine when exposed to a traumatic factor. Corpectomy in combination with posterior decompression and restoration of the spinal support function is often performed using an interbody implant and posterior transpedicular stabilization to achieve adequate decompression and stabilization in severe traumatic injuries of this level. The surgery of this type is characterized by significant instability of the operated segment and determines increased requirements for the rigidity and reliability of posterior fixation. We have modeled the situation of a two-level corpectomy with subsequent replacement of bodies with a mesh implant and posterior transpedicular stabilization with 8 screws. Objective. To study the stress-strain state of the thoracolumbar spine model after resection of the Th12-L1 vertebrae with different variants of transpedicular fixation under the influence of a compressive load. Materials and methods. A mathematical finite element model of the human thoracolumbar spine has been developed, the components of which are the Th9 ‒ Th11 and L2-L5 vertebrae (vertebrae Th12-L1 are removed), as well as elements of hardware - interbody support and transpedicular system. Four variants of transpedicular fixation were modeled: using short screws and long screws passing through the cortical layer of anterior wall of vertebral body, as well as two cross links and without them. The stress-strain state of the models was studied under the influence of a vertical compressive distributed load, which was applied to the body of the Th9 vertebra and its articular surfaces. The load value was 350 N, corresponding to the weight of the upper body. Results. d It was found that transpedicular fixation of the thoracolumbar vertebrae with the use of long screws reduces the level of tension in the bone elements of the models. In the area of screw entry into the pedicle of the T10, T11, L2 and L3 vertebral arch, the load when using short screws was 3.1, 1.7, 3.9 and 12.1 MPa, respectively, when using bicortically installed screws - 2.9, 1.8, 3.8 and 10.6 MPa. The addition of two cross-links also reduces the maximum load values in critical areas of the model to a certain extent. In case of short screws combination and two cross-links, the load in these areas was 2.8, 1.7, 3.6 and 11.5 MPa, when using bicortical screws and cross-links - 2.8, 1.6, 3.3 and 9.3 MPa. The study of the stress-strain state of other parts of the model revealed a similar trend. Conclusions. The use of long screws with fixation in the cortical bone of anterior part of the vertebral bodies reduces the level of tension in the bone elements of the models. The use of cross links provides greater rigidity to the transpedicular system, that also reduces the tension in the bone tissue.