Biomechanical Evaluation of Fourth Generation Minimally Invasive Distal First Metatarsal Osteotomy-Akin Osteotomy Technique on First Ray Articular Contact Properties.

Abstract

Hallux valgus is a common deformity encountered but remains a complex clinical entity. Fourth-generation minimally invasive surgery (MIS) techniques consisting of a percutaneous distal metatarsal transverse osteotomy combined with an Akin osteotomy have been used to address mild to severe hallux valgus deformities. The benefits of an MIS approach include improved cosmesis, faster recovery, lower opiate requirement, immediate weightbearing, and favorable outcomes relative to a traditional, open procedure. An understudied area with respect to hallux valgus correction is the effect that osteotomies can have on the articular contact properties of the first ray following correction. Sixteen paired cadaveric specimens were dissected to include the first ray and tested in a customized apparatus. Specimens were randomized to receive a distal transverse osteotomy translated either 50% or 100% of the width of the first metatarsal shaft. The osteotomy was performed with either a 0° or 20° distal angulation of the burr relative to the shaft in the axial plane. Specimens were tested in the intact state and following the distal first metatarsal osteotomy for peak pressure, contact area, contact force and center of pressure at the first metatarsophalangeal (MTP) and first tarsometatarsal (TMT) joints. An Akin osteotomy was then performed on each specimen, and peak pressure, contact area, contact force, and center of pressure were recalculated. There was a notable decrease in peak pressure, contact area, and contact force across the TMT joint with greater shifts of the capital fragment. However, at 100% translation of the capital fragment, distal angulation of the osteotomy by 20° appears to improve loading across the TMT joint. Addition of the Akin osteotomy at 100% translation also aids in increasing the contact force across the TMT joint. The MTP joint is less sensitive to changes in shifts and angulation of the capital fragment. The Akin osteotomy also leads to increased contact force across the MTP joint when the capital fragment is translated 100%. While the clinical significance is unknown, larger shifts of the capital fragment lead to greater load alterations at the level of the TMT joint than the MTP joint. Distal angulation of the capital fragment and the addition of an Akin osteotomy can aid in reducing the size of those changes. The Akin can lead to increased contact forces at the MTP joint with 100% translation of the capital fragment. Not applicable, Biomechanical study.