Biomechanical changes of oblique lumbar interbody fusion with different fixation techniques in degenerative spondylolisthesis lumbar spine: a finite element analysis

Abstract

ObjectiveThere is a dearth of comprehensive research on the stability of the spinal biomechanical structure when combining Oblique Lumbar Interbody Fusion (OLIF) with internal fixation methods. Hence, we have devised this experiment to meticulously examine and analyze the biomechanical changes that arise from combining OLIF surgery with different internal fixation techniques in patients diagnosed with degenerative lumbar spondylolisthesis.MethodsSeven validated finite element models were reconstructed based on computed tomography scan images of the L3-L5 segment. These models included the intact model, a stand-alone (S-A) OLIF model, a lateral screw rod (LSR) OLIF model, a bilateral pedicle screw (BPS) OLIF model, an unilateral pedicle screw (UPS) OLIF model, a bilateral CBT (BCBT) OLIF model, and an unilateral CBT(UCBT) OLIF model. The range of motion (ROM), as well as stress levels in the cage, L4 lower endplate, L5 upper endplate, and fixation constructs were assessed across these different model configurations.ResultsS-A model had the highest average ROM of six motion modes, followed by LSR, UPS, UCBT, BPS and BCBT. The BCBT model had a relatively lower cage stress than the others. The maximum peak von Mises stress of the fixation constructs was found in the LSR model. The maximum peak von Mises stress of L4 lower endplate was found in the S-A model. The peak von Mises stress on the L4 lower endplate of the rest surgical models showed no significant difference. The maximum peak von Mises stress of the L5 upper endplate was found in the S-A model. The minimum peak von Mises stress of the L5 upper endplate was found in the BCBT model. No significant difference was found for the peak von Mises stress of the L5 upper endplate among LSR, BPS, UPS and UCBT models.ConclusionAmong the six different fixation techniques, BCBT exhibited superior biomechanical stability and minimal stress on the cage-endplate interface. It was followed by BPS, UCBT, UPS, and LSR in terms of effectiveness. Conversely, S-A OLIF demonstrated the least stability and resulted in increased stress on both the cage and endplates. Combining OLIF with BCBT fixation technique enhanced biomechanical stability compared to BPS and presented as a less invasive alternative treatment for patients with degenerative lumbar spondylolisthesis.