Abstract
The feasibility of removing sulphate using low-density polypropylene pellets as carrier material in two lactate-fed sulphidogenic inverse fluidized-bed reactors was investigated. Two different COD/sulphate ratios and two different feed–sulphate concentrations were used for the operation of the reactors. During the 242 days of operation, the robustness of the system was studied by suddenly decreasing the feed pH to 3.00. A 10% fluidization degree was used since the carrier material adopted showed not to be adequate to attain a satisfactory immobilization of the biomass with higher fluidization degrees. This resulted in a failure of the process when the feed pH was intentionally decreased to 3.00 in reactor 2, operated with a COD/sulphate ratio of 4.00. On the contrary, when a slightly acidic feed solution was fed to reactor 2, a 97% sulphate reduction efficiency was obtained. In reactor 1, operated with a COD/sulphate ratio of 0.67 throughout the experiment, COD removal and sulphate reduction efficiencies reached the highest values of 75% and 35%, respectively. Higher efficiencies were not achieved also due to the accumulation of acetate and the most likely presence of microbial competition between sulphate reducers and other microorganisms.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.