Abstract
Lignin can be obtained as a byproduct during cellulose-rich pulp fibers production and it is habitually treated as waste or intended for low-value destinations. However, due to UV absorption and mechanical properties, lignin can contribute to the fabrication of biodegradable blown films with superior performances. In this study, it was established the suitability of lignin for manufacturing biocomposite PBAT blown films with higher stiffness and photo-oxidation resistance. The effect of the filler concentration on the melt rheological behavior in non-isothermal elongational flow was investigated. The results allowed us to choose the correct filler concentration for producing films through a film blowing operation. The PBAT/lignin blown film composites displayed an increase of the elastic modulus if compared to neat PBAT films without affecting their elongation at break. Furthermore, the filler delayed the photo-oxidative degradation of PBAT hence potentially allowing open-air applications.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callSimilar Papers
More From: International Journal of Biological Macromolecules
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
