Abstract

We demonstrate a facile and effective way for the fabrication of a flexible, homogeneous and neat α-MoO3 thin-film electrode for lithium-ion batteries with high performance without using any binder and conductive additives. Single-crystalline α-MoO3 nanobelts with uniform width of around 200 nm and length at the micrometer level are first synthesized by a simple water-based hydrothermal route. The as-obtained α-MoO3 slurry is then directly deposited onto a copper foil current collector by the doctor blade method. The formation of the α-MoO3 film and its good adhesion to the current collector is realized via van der Waals attraction forces through a drying process. The structure and morphology of the α-MoO3 nanobelt particles and thin-film electrode are systematically characterized by XRD, Raman spectra, TEM, SEM and XPS techniques, and the electrochemical properties are investigated by CV and constant current discharge–charge test techniques. The α-MoO3 film electrode exhibits a reversible specific capacity of ∼1000 mA h g−1 at 50 mA g−1 and a stable capacity retention of 387–443 mA h g−1 at 2000 mA g−1, indicating its high Li storage capacity, superior rate performance and good cycling stability. The electrode material, as well as the fabrication technique, is highly promising for practical use in high energy and power density lithium-ion batteries.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.