Abstract
Various morphologies have been observed in sputter-deposited Be ablator capsules, including nodular growth, cone growth and twisted grain growth. By devising an agitation method that includes both bouncing and rolling the spherical mandrels during deposition, and by reducing the coating rate, consistent columnar grain structure has now been obtained up to 170 mm. Low mode deformation of the shells is observed on thin CH mandrels, but is suppressed if stiffer mandrels are used. Ablator density measured by weighing and x-ray radiography is 93%–95% of bulk density of Be. Transmission electron microscopy shows 100.200 nm size voids in the film and striations inside the grains. Be shells produced with rolling agitation have met most of the NIF specifications. Some of the few remaining issues will be discussed.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
