Abstract

MEPS Marine Ecology Progress Series Contact the journal Facebook Twitter RSS Mailing List Subscribe to our mailing list via Mailchimp HomeLatest VolumeAbout the JournalEditorsTheme Sections MEPS 196:59-73 (2000) - doi:10.3354/meps196059 Benthic-pelagic exchange of microalgae at a tidal flat. 1. Pigment analysis Cathy H. Lucas1,*, John Widdows2, Mary D. Brinsley2, Peter N. Salkeld2, Peter M. J. Herman3 1School of Ocean and Earth Science, University of Southampton, Southampton Oceanography Centre, European Way, Southampton SO14 3ZH, United Kingdom 2Centre for Coastal and Marine Sciences, Plymouth Marine Laboratory, Prospect Place, The Hoe, Plymouth PL1 3DH, United Kingdom 3Netherlands Institute of Ecology (NIOO-CEMO), PO Box 140, 4400 AC Yerseke, The Netherlands *E-mail: catherine.h.lucas@soc.soton.ac.uk ABSTRACT: Annular flume experiments and high-performance liquid chromatography (HPLC) were used to quantitatively and qualitatively measure benthic-pelagic exchange of microphytobenthos from natural sediments. Clear spatial and temporal differences in microphytobenthos resuspension in response to stepwise increases in current velocity were observed. Resuspension of chlorophyll a (chl a) from sandy sediments containing low levels of microphytobenthos biomass (<11.5 mg chl a m-2) occurred gradually and continuously over a range of current velocities from 10 to 40 cm s-1. In June, well-developed diatom mats at siltier sites (>56 mg chl a m-2) displayed strong resistance to erosion at currents <20 to 25 cm s-1, above which there was a very rapid increase in the amount of chl a in suspension following the stripping of the algal mat from the sediment surface. In September, when the diatom bloom was over, these sediments were less resistant to erosion and resuspension of microalgae occurred at current velocities above 15 to 20 cm-1. Site 1, situated at the edge of the flat, had a dense algal mat but low sediment stability. Microalgae were readily resuspended because the extracellular polymeric substances (EPS) produced by the migratory diatoms were unable to consolidate during the short emersion period. As a rule more chl a was resuspended from sandy sediments at current velocities 15 and 20 cm-1, but above this current velocity chl a resuspension was greater from silty sediments. Although sandy sites have low biomass in the surface layer, the greater depth of sediment erosion during bedload transport exposes more chl a to the surface. The percentage of sedimentary chl a lost at selected current velocities was estimated, and the implications for carbon supply to the pelagic and benthic systems discussed. Much of the biomass resuspended may be deposited locally, particularly in sandier regions. During the flume experiments it was observed that settling of fine sediment and microalgae was extremely rapid, because it was being biodeposited by suspension-feeding activity, and Œstripped¹ out of the water column by rapidly sinking suspended particulate matter (SPM). Qualitative changes in suspended material were measured as % chl a (chl a/phaeopigments x 100%) and accessory pigment content. As current velocity increased the relative proportion of phaeopigments increased, which has important implications for benthic suspension feeders feeding in the benthic boundary layer. The findings from the flume experiments have been compared with in situ measurements of current velocity, SPM and chl a. KEY WORDS: Microphytobenthos · Resuspension · Deposition · Chlorophyll a · Accessory pigments · HPLC · Annular flume Full text in pdf format PreviousNextExport citation RSS - Facebook - Tweet - linkedIn Cited by Published in MEPS Vol. 196. Publication date: April 18, 2000 Print ISSN:0171-8630; Online ISSN:1616-1599 Copyright © 2000 Inter-Research.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.