Abstract
This research is based on the purposes to find suitable hot compression conditions of composites materials, also to optimize mechanical and biological properties of the plate specimen. The type of composites materials under this investigation are bio-polymers (polylactic acid: PLA) and bio-ceramic (Hydroxyapatite: HA). In this research, the term “The design of the experiment (DOE)” was implemented to find the relation between forming factors including the ratio of HA ratio, molding temperature, and molding pressure. The result showed that the optimum conditions of the bending test were at 5%wt. of HA, 160 °C, 7 MPa of molding temperature and pressure respectively. Biodegradation rate of a specimen was 0.0175 g/day and the specimens acquired a good biocompatibility and they were non-toxic to living cells.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IOP Conference Series: Materials Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
