Benchmark analysis of the FFTF LOSWOS test #13 with OpenMC and THACS

Abstract

In order to support collaborative efforts within international partnerships on the development of sodium-cooled fast reactor (SFR), the International Atomic Energy Agency (IAEA) proposes a coordinated research project (CRP) about the unprotected loss-of-flow-without-scram test (LOSWOS) performed at Fast Flux Test Facility (FFTF) in 2018, which could validate simulation tool and numerical models for SFR. As one of the participants, the Nuclear THermal-hydraulic Laboratory at Xi’an Jiaotong University (NuTHeL) participates with the monte carol code OpenMC and system thermal hydraulic code THACS. This paperdeal with the standalone neutronic modeling by OpenMC and thermal hydraulic modelling by THACS. For neutronic part, the axial homogenous model was modeled to analyze the reactivity feedback coefficients and steady radial power distribution. For thermal hydraulic part, the system model, including 2D CFD outlet plenum model, subchannel model and inter-wrapper flow model, was modeled to analyze both system response and local phenomena during the LOSWOS. In general, both neutronic results and thermal hydraulic results agreed well with other participants or experiments, the reactivity feedback of GEM could provide major negative feedback, which could be used as a novel passive shutdown device. However, the remaining discrepancies were the underestimated peak temperature of PIOTA at the begin of transients, it may be caused by unknow heat transfer coefficients around hexagon tube, which has no correlation and should be further investigated by experiments. In addition, when considering IWF model, the maximum temperature of the outlet for the active fuel region was 10 K larger than the subassemblie’ outlet in the PIOTA, this phenomenon should be carefully treated in loss of flow accidents of SFR.