Bench-scale production of liquid fuel from woody biomass via gasification

Abstract

Listen

Translate article

The bench-scale production of hydrocarbon liquid fuel was achieved from woody biomass via gasification. The daily production capacity of the biomass-to-liquid (BTL) plant used in this study was 7.8 L of hydrocarbon liquid from 48 kg of woody biomass (on a dry basis), corresponding to 0.05 barrels. The BTL process involved the following steps: oxygen-enriched air gasification of the woody biomass, wet and dry gas cleaning, gas compression, carbon dioxide removal, and the Fischer–Tropsch (FT) synthesis reaction. In the gasification step, oxygen-enriched air gasification was carried out using a downdraft fixed-bed gasifier. The content of oxygen, which acts as the gasifying agent, was increased from 21.0 to 56.7 vol%; maximum values of the conversion to gas on a carbon basis and cold gas efficiency–approximately 96 C-mol% and 87.8%, respectively–were obtained at an oxygen content of around 30 vol%. With the increased oxygen content, the concentrations of CO, H 2, and CO 2 increased from 22.8 to 36.5 vol%, from 16.8 to 28.1 vol%, and from 9.8 to 14.8 vol%, respectively, while that of N 2 decreased from 48.8 to 16.0 vol%. The feed gas for the FT synthesis reaction was obtained by passing the product gas from the gasification step through a scrubber, carbon dioxide removal tower, and desulfurization tower; its composition was 30.8 vol% CO, 25.2 vol% H 2, 0.9 vol% CO 2, 2.5 vol% CH 4, 40.6 vol% N 2, < 5 ppb H 2S, and < 5 ppb COS. The hydrocarbon fuel was synthesized in a slurry bed reactor using hexadecane as the solvent and a Co/SiO 2 catalyst. For hydrocarbons with carbon chain lengths of more than 5 carbon atoms (collectively referred to as C 5+) in the liquid fuel, a selectivity of 87.5% was obtained along with a chain growth probability of 0.84 under the following conditions: 4 MPa, 280 to 340 °C, and a ratio of catalyst weight to feed gas rate (W/F) of 9.3 g·h/mol.