Abstract

The behaviour of heavy metals in the partial oxidation of heavy fuel oils under a pressure of up to 100 bar (10 MPa) has been investigated. The tests were carried out in a 5 MW HP POX (High Pressure Partial Oxidation) test plant, that is operated by the IEC (Department of Energy Process Engineering and Chemical Engineering, TU Bergakademie Freiberg) in cooperation with Lurgi GmbH. In several test campaigns preheated oil with a viscosity of up to 300 cSt (= 300 mm 2/s) at the burner inlet has been gasified. The heavy metals nickel Ni, iron Fe and vanadium V occur in heavy residual oils in considerable concentration and may seriously impact the gasification itself and the synthesis gas conditioning and usage. While iron is largely recovered in the gasification residue, the recovery rates of nickel and vanadium depend on the process conditions. Volatile nickel compounds were detected in the raw synthesis gas. It was found that an incomplete carbon conversion enables the capture of nickel Ni and vanadium V in the solid residue phase and can thus mitigate the problem of volatile metal compounds in the raw synthesis gas.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.