Abstract
The morphology of monatomic step edges on vicinal Si (001) surfaces is briefly reviewed. With increasing miscut angle, the Si (001) surface exhibits an interesting sequence of phase transitions. For a miscut angle smaller than about 0.03°, a hilly structure with step loops is found, whereas a phase of wavy steps coexisting with a phase of straight steps is observed in the range of 0.03°–0.1°. If the miscut angle lies in the range of 0.1° up to about 3°, two types, one much straighter than the other, of monatomic step edges develop. For even larger miscut angles, a phase of straight biatomic step edges is found. The fundamental energetic parameters, like kink formation energies, step edge energies and step-step interactions, which govern the thermodynamic behavior are determined using Scanning Tunneling Microscopy (STM) images of 0.5° misoriented Si (001). Despite the weak strength of energetic and entropic step-step interactions as compared to the interactions along the step edge, i.e. the kink formation and step edge energies, they have a profound effect on the meandering of the step edges. Both entropic and energetic step-step interactions are proportional to L−2 (where L is the average terrace length). The behavior of the step edges at temperatures above room temperature will be addressed with the aid of a high-temperature STM. The freeze-out temperature, T f , of the monatomic step edges is estimated to be higher than 600–700 K. The temperature T f is significantly above the roughening temperature, Tr, of the step edges. This means that at room temperature, the monatomic step edges on vicinal Si (001) are always rough.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.