Behavior of large-scale concrete columns reinforced with high-strength and high-toughness steel bars under axial and eccentric compression

Abstract

In this paper, combined with the current era background of energy saving and emission reduction, low carbon and environmental protection, the mechanical performance of new high-strength and high-toughness steel bars (HSHTSB) in concrete structural members is studied, and HSHTSB is expected to be popularized. To investigate the compression behavior of large-scale concrete columns reinforced with HSHTSB under axial and eccentric compression, thirteen reinforced concrete (RC) columns were designed in this paper, including the five columns under axial compression and the eight columns under eccentric compression. The effects of different types of steel bars, transverse steel bar spacing, the configuration of transverse steel bars, and eccentricity on failure modes, load-deformation curves, load-strain curves, ultimate bearing capacity, deformation capacity, and energy absorption capacity were studied in detail. The results show that the cracks are more uniform for concrete columns reinforced with HSHTSB. When the transverse steel bar spacing is less than 80 mm, concrete columns reinforced with HSHTSB with eccentricity ≤200 mm (including eccentricity = 0) have obvious secondary bearing phenomenon, and significantly improve ductility and energy absorption capacity; HSHTSB as longitudinal steel bars can reach yield strength for RC columns under axial compression. For RC columns under eccentric compression, HSHTSB could not reach yield strength on both the tensile and compression side. For the RC columns of Group II, III, and IV, when the eccentricity increases from 100 mm to 400 mm, the ultimate bearing capacity decreases by 76.1%, 75.2%, and 75.1%, respectively. Different from the ordinary RC columns, the ductility decreases with the increase of eccentricity for concrete columns reinforced with HSHTSB. Compared with ordinary RC columns, the energy absorption capacity and deformation capacity of concrete columns reinforced with HSHTSB under axial compression are increased by 120.9% and 116.9%, respectively. Compared with RC columns using transverse steel bars with single-leg, the energy absorption capacity and ductility for multiple-leg can be increased by 111.5% and 103.2%, respectively. When the eccentricity increases from 100 mm to 400 mm, the ductility for columns of Group II and III decreases by 73.5% and 65.9%, respectively. The use of HSHTSB can save the number of longitudinal steel bars and the transverse steel bar spacing while maintaining the bearing capacity, and further improve the deformation capacity. Based on the section strain analysis, the analytical models of the ultimate bearing capacity for the concrete columns reinforced with HSHTSB were established with high accuracy.