Behavior of alloy Ti–6Al–4V under pre-fretting and subsequent fatigue conditions

Abstract

The mechanical behavior and microstructural changes in Ti–6Al–4V were determined in fretting tests, followed by axial fatigue tests. Prior to fatigue testing, specimens were subjected to fretting conditions over a range of contact stresses and fretting displacements. Fretting frequency was 100Hz. High cycle fatigue (HCF) tests were run at 1000Hz. The fretting test involved a flat-on-flat, bare Ti–6Al–4V/bare Ti–6Al–4V fretting system. The fretting process typically generated very shallow surface cracks at the ends of the wear scar. Subsequently, these shallow cracks were observed to propagate in axial fatigue tests, reducing the fatigue life significantly. Evidence of frictional heating during fretting was observed in the formation of scale-like oxide in the wear scar. Formation of oxides appeared to increase with increasing contact stress. Increased oxygen content was detected in the near surface regions of specimens. Large near surface deformation was typically observed within the wear scar. The contact geometry and slight tilting of the stationary fretting pad influenced the character of the fretting scar and the fretting-induced cracking. Fracture surfaces exhibited featureless, battered surfaces at the crack origins followed by (a) cleavage-type crack propagation, (b) formation of fatigue striations, and (c) final ductile tearing.