Abstract
Batch foaming processes were employed to prepare plastic foams from polypropylene (PP)/polydimethylsiloxane (PDMS) blends. Various amounts of PDMS were added to a PP matrix, and the resulting blends were batch foamed at different saturation pressures using carbon dioxide (CO2) as the blowing agent. Ultimately, the blend foams exhibited better cell morphologies and higher cell densities in comparison with those prepared from PP alone. The increased solubility of CO2 in PDMS made it as a CO2 reservoir to induce more nucleation. When the PDMS content exceeded a certain level, however, it exerted a negative influence on cell density. Moreover, as the saturation pressure was raised, the cell density of the blend foams increased significantly. It was also noted that the addition of PDMS to the PP matrix generated some very small cells in the larger cell walls.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: International Journal of Polymeric Materials and Polymeric Biomaterials
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.