Abstract
For the importance of automobile light and hard to design problem, the application of high level injection tooling Moldflow was used. Through analyzed with Moldflow and combined the actually mold tooling developed experience, the lens of the automobile light developed successfully. The results show that the mold injection gate position and Hot-runner type are quite reasonable. The designed sub-runner and injection process parameter are suitable. There are no air traps and weld line with this mold to produce the auto light lens. The shrinkage of the product is even and the maximum shrinkage value is below 4% that fulfill the plastic demand. Using the Moldflow can reduce the development cycle, the experiment time and improve the product quality and working efficiency.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.