Barley Malt as a Binder for Moulding Sands—Gas Evolution and Surface Quality of Iron Castings

Abstract

The requirements placed on the foundry industry are mainly related to the need to maintain an appropriate quality–price ratio of the product and to maintain an appropriate production regime that takes into account modern legal solutions related to environmental protection. This work is part of the trend of searching for new or previously unused materials from renewable sources in moulding sand technology. This article concerns the possibility of using barley malt in moulding material technology as a binding material. The presented work contains the results of research on the release of gases during casting, where high temperatures cause the decomposition of chemical substances. The tests confirmed that moulding sands with barley malt as a binder do not cause excessive emissions of harmful gaseous products when pouring moulds with liquid casting alloy. The volume of gases formed was smaller than that of commonly used moulding sands with other binders. The total volume of gases produced and the kinetics of their release indicate that casting in this type of moulding sand did not cause any technological inconvenience or casting defects of gaseous origin. This was confirmed by research involving obtaining iron castings in industrial conditions using barley malt as a binder in moulding sand technology, which were then subjected to visual assessment and roughness analysis.