Abstract
In telecommunication, filters are often used to pass the desired frequency. One of them is the Band-Pass Filter (BPF) which is passing signals between the upper cut-off frequency and the lower cut-off frequency. This research aims to make a band-pass filter that can pass 3 GHz frequency with a bandwidth of 200 MHz. This filter is designed with a square open-loop resonator simulated using Advanced Design System (ADS) software. The filter is made using FR 4-epoxy substrates with a dielectric constant (ε ) of 4.6 and substrate thickness (h) of 1.6 mm. Based on the simulation results obtained in the form of a comparison graph between the response of magnitude to frequency, it shows that the value of the return loss (S 11 ) parameter of -23.549 dB, insertion loss (S 21 ) parameter value of -1.397 dB, and a slightly shifted middle frequency of 2.890 GHz. Then for the measurement results obtained a parameter value return loss (S 11 ) of -16.364 dB, parameter value insertion loss (S 21 ) of -3.561 dB with a center frequency of 3.185 GHz.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
