Abstract
Material and structure made by additive manufacturing (AM) have received much attention lately due to their flexibility and ability to customize complex structures. This study first implements multiple objective topology optimization simulations based on a projectile perforation model, and a new topologic projectile is obtained. Then two types of 316L stainless steel projectiles (the solid and the topology) are printed in a selective laser melt (SLM) machine to evaluate the penetration performance of the projectiles by the ballistic test. The experiment results show that the dimensionless specific kinetic energy value of topologic projectiles is higher than that of solid projectiles, indicating the better penetration ability of the topologic projectiles. Finally, microscopic studies (scanning electron microscope and X-ray micro-CT) are performed on the remaining projectiles to investigate the failure mechanism of the internal structure of the topologic projectiles. An explicit dynamics simulation was also performed, and the failure locations of the residual topologic projectiles were in good agreement with the experimental results, which can better guide the design of new projectiles combining AM and topology optimization in the future.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.