Ballistic and Charpy impact performance of basalt fiber reinforced polymer composites

Abstract

AbstractIn this study, the behavior of composite material produced using basalt, a natural fabric, under ballistic and Charpy impact loads was investigated. The damage resistance of target plates under ballistic loads is an important design parameter in the structures that will be exposed to these loads. Cross‐ply fiber‐reinforced composite plates were produced with different numbers of layers. The composite specimens are produced using the vacuum infusion method, cross‐ply laminated with 3, 6, 9, and 12 layers ([0/90]3, [0/90]6, [0/90]9, and [0/90]12). Carbon/Epoxy specimens were also produced in identical sequences to be used as comparison material. The study aimed to understand the absorbed energy under ballistic loads and the required energy level under the Charpy impact loads of Basalt/Epoxy composite specimens with different thicknesses. Ballistic loads are applied to the specimens using a test set‐up including the sample holder mechanism and a firing system. Charpy impact tests were conducted using a standard test machine. According to the results, for 12‐layer specimens, the residual velocity difference between Basalt/Epoxy and Carbon/Epoxy is approximately 1.5 times. For the Basalt/Epoxy plate, increasing number of layers from 3 to 12 increases the amount of energy absorbed approximately 13 times. Although this increase is approximately 19 times for the Carbon/epoxy plate, when Basalt/Epoxy and Carbon/Epoxy plates are compared, Basalt/Epoxy absorbs more energy for all layer numbers. For the Charpy impact cases, it has been observed that Basalt/Epoxy absorbs approximately 34% more energy for flat wise impact and approximately 24% more energy for edgewise impact.Highlights The behavior of composite material produced using basalt, a natural fabric. Cross‐ply fiber‐reinforced composite plates. Effect of different number of layers considered. The damage resistance of target plates under ballistic loads. Comparison of basalt and carbon‐reinforced composites.