Abstract

In the following paper we describe arrangements of laser interferometer for investigation of screws and for inspection of ball screws. We have constructed two of them, namely: the technological setup for investigations of screw in process of production and the ball screw inspection setup. The former one is used to measure the pitch of screws. The data gathered during measurement is used to calculate the parameters for grinding machine. The later setup is used for testing parameters of complete ball screws. The software supporting this setup makes calculation of parameters of tested ball screw and creation of reports possible. Additionally, the inspection setup is the one that the torque measuring arrangements have been integrated on. Both the arrangements and the software allow for measurements of all parameters during movement of nut in full travel length of the ball screw and make charts and reports.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.