Abstract
<p>This paper describes the design and the simulation of a non-linear controller for two-mass system using induction motor basing on the backstepping method. The aim is to control the speed actual value of load motor matching with the speed reference load motor, moreover, electrical drive’s respone ensuring the “fast, accurate and small overshoot” and reducing the resonance oscillations for two-mass system using induction motor fed by voltage source inveter with ideally control performance of stator current. Backstepping controller uses the non-linear equations of an induction motor and the linear dynamical equations of two-mass system, the Lyapunov analysis and the errors between the real and the desired values. The controller has been implemented in both simulation and hardware-in-the-loop (HIL) real-time experiments using Typhoon HIL 402 system, when the drive system operates at a stable speed (rotor flux is constant) and greater than rated speed (field weakening area). The simulation and HIL results presented the correctness and effectiveness of the controller is proposed; furthermore, compared to PI method to see the response of the system clearly.</p>
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: International Journal of Power Electronics and Drive Systems (IJPEDS)
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.