Abstract
This article presents the development of a simple and non-iterative method to calculate available transfer capability (ATC) for a transmission system using a new set of distribution factors. Sets of power transfer distribution factors and voltage distribution factors have been obtained using the sensitivity based approach for system intact, as well as contingency cases, and utilized to check line flow limits and voltage limits during ATC determination. The accuracy of these distribution factors have been established with respect to full NRLF results and ATC results have been obtained for bilateral and multilateral transactions on IEEE 24-bus Reliability Test System (RTS) system and a 75-bus Indian system network.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
