Abstract

IntroductionSeveral conditions can cause penile length and girth loss. Surgical techniques have been used to restore these penile alterations in patients with severe erectile dysfunction during penile prosthesis implantation. One technique uses multiple small incisions in a mesh pattern (similar to a skin mesh) with satisfactory curvature correction without using a graft, however, this technique does not allow simultaneous increase in penile length and girth.AimTo identify a new surgical technique that increases both the length and girth at the same place on the corpora cavernosa (CC), allowing a simultaneously longitudinal and transverse increase of the tunica albuginea.MethodsA sheet with a star-shaped perforation was created using a mathematical model to allow a longitudinal and transversal increase in the material. Two previously published penile model simulators, with and without deformity, were used to test the mechanical modification of this incision pattern in the CC.Main Outcome MeasureThe effect of the incisions pattern on the geometry of the CC simulator.ResultsThe star-shaped incision (auxetic) simultaneously increased the length, girth, and volume of the CC simulator. This auxetic technique could correct any penile deformity, re-establishing the original penile anatomy. The new auxetic incision is only a conceptual and experimental technique awaiting clinical evidence.ConclusionThe data presented here show that the auxetic technique successfully increases both the length and girth at the same place on the CC simulators, opening a new potential solution to correct challenging cases of complex penile deformities and to restore volume loss.Miranda A, Auxetic Expansion of the Tunica Albuginea for Penile Length and Girth Restoration Without a Graft: A Translational Study. Sex Med 2021;9:100456.

Highlights

  • Several conditions can cause penile length and girth loss

  • Some surgical techniques have been created to restore penile length loss (PLL) in patients with severe erectile dysfunction submitted to penile prosthesis implantation (PPI),[4] including multiple transverse tunica albuginea (TA) incisions without graft, which straightens and lengthens the penis

  • Short C values are unable to overcome tension generated during corpora cavernosa (CC) dilation or the insertion of a penile prosthesis [mainly with an inflatable penile prosthesis (IPP) via radial expansion], which results in rupture

Read more

Summary

Introduction

Several conditions can cause penile length and girth loss. Surgical techniques have been used to restore these penile alterations in patients with severe erectile dysfunction during penile prosthesis implantation. Results: The star-shaped incision (auxetic) simultaneously increased the length, girth, and volume of the CC simulator This auxetic technique could correct any penile deformity, re-establishing the original penile anatomy. Conclusion: The data presented here show that the auxetic technique successfully increases both the length and girth at the same place on the CC simulators, opening a new potential solution to correct challenging cases of complex penile deformities and to restore volume loss. Penile length and girth loss may be caused by many conditions like Peyronie’s disease (PD), postradical prostatectomy, erectile dysfunction following ischemic priapism.[1,2,3] Some surgical techniques have been created to restore penile length loss (PLL) in patients with severe erectile dysfunction submitted to penile prosthesis implantation (PPI),[4] including multiple transverse tunica albuginea (TA) incisions without graft, which straightens and lengthens the penis. It is not possible to increase both length and girth at the same place on the corpora cavernosa (CC), a phenomenon that occurs due to mechanical properties of the TA.[8]

Objectives
Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call