Abstract
Summary Many horizontal oil wells will after a time start producing unwanted fluids. Autonomous inflow control valves may help to choke these unwanted fluids and consequently improve carbon efficiency. This paper publishes new experimental data describing how an autonomous inflow control valve manages medium-light oil (6 cp), water, and gas at reservoir conditions. A further objective is to evaluate how this valve might impact well performance under various conditions. To verify the single- and multiphase flow behavior of the valve, extensive flow loop experiments were performed. Initial testing was done in a model fluid laboratory, while a more extensive test was performed at reservoir conditions (i.e., with formation water, reservoir oil, and hydrocarbon gas at the given reservoir temperature and pressure). To explore and understand the impact of this valve for various reservoir scenarios, a simple conceptual reservoir model with realistic boundary conditions was used. At various differential pressures, the single-phase oil, water, and gas rates were measured. Performance at varying water and gas fractions was measured to get an improved understanding and knowledge of multiphase flow occurring in a well. The results show clearly that the valve will choke gas and water effectively, both at single-phase and multiphase flow conditions. The reservoir and model fluid evaluations show consistent results. The valve shows roughly a monotonic decreasing total rate with decreasing oil fraction, implying that the valve will always prioritize sections with the largest oil fraction. A mathematical model match of the valve performance is possible via the 10-parameter extended autonomous inflow control device (AICD) equation that enables practical evaluation of the valve in industry-standard reservoir simulators. Various scenarios are explored with a conceptual reservoir model, and the autonomous inflow control valve shows its capacity to reduce water production and enable a more gradual and controlled increase in gas/oil ratio for most scenarios. The autonomous inflow control valve shows its largest potential to reduce unwanted fluids and increase oil recovery when used in segmented reservoirs. In cases with uncertain aquifer and/or gas cap strength, or large variation in effective permeability, the valve will make an infill well more robust as it autonomously adapts to reality, chokes unwanted fluids, and consequently enables more carbon-efficient reservoir management.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
