Abstract

This investigation was performed with the purpose of comparing the arodynamic drag of an automobile as measured in a full-scale wind tunnel with the drag as measured on the road. A definition of the drag coefficient as measured both on the road and in the wind tunnel is given in advance in order to allow a comparison to be made between the two operating conditions. Three medium size european cars were selected, one notch-back type and two hatch-back types. Road testing was mainly based on the coast-down method. The total resistance was determined by statistical analysis of the experimental results. The theoretical basis and the specifications of the procedure are investigated and justified. Additional outdoor and indoor tests were carried out in order to isolate the aerodynamic drag. The wind tunnel tests were conducted on the same cars fully equipped as tested on the road and in the same speed range. The wind tunnel tests being executed at steady speeds, however, supplementary road tests were performed in order to determine the effect of the deceleration on the aerodynamic drag. The final results show only small differences between the aerodynamic drag coefficients as measured in the wind tunnel and on the road with the procedure here described

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.