Abstract
Grinding is difficult to control because abrasive grains are scattered randomly on the surface of the grinding wheel, and the quality of the grinding work is strongly dependent on the skill of the operator. Therefore, automation and optimization technologies should be established immediately for grinding, along with other machining work. From this perspective, we observed the bending vibrations of a diamond wheel during a grinding project and developed a technique to identify the grinding condition by using a microphone to measure the small noises from the vibration (called bending-vibration noise in this paper). In this paper, we report the application of the technique to an ordinary grinding wheel, and our attempt to automate the grinding work of STAVAX and SKD11 metal materials.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.