Abstract
The paper describes a measurement technique for conducted EMI measurements. This technique allows a bandwidth improvement in the spectrum analysis of conducted interference produced by a single-phase EUT with respect to the measurement procedure prescribed by the (CISPR 16) Standard Rules. The technique makes reference to the common-mode and differential-mode components of voltage and current measured at a point of the line by sensors with adequate characteristics in absence of dummy loads. The experimental tests performed with the proposed technique have been carried out on a widespread switched-mode power supply. The extension to three-phase systems is also proposed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Instrumentation and Measurement
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
